TelePresence and Video Infrastructure

I have four E+M connection tie-line 4-wire immediate signalling circuits. I can seize the tie-lines from direct trunk select and receive dial-tone from the router ports but, i cannot break local dialtone. debugging shows the transition from onhook to...

Hi all,I can't seem to get my Cisco Gatekeeper to work with my Radvision Gateway L2W? I can get the Gateway to connect to the Gatekeeper. The dial prefixes show up in the GATEWAY TYPE PREFIX TABLE. I cannot get a Polycom Via Video or Viewstation t...

Is there any way to broadcast an IPVC via IPTV? I seem to recall from this forum that it could be done via h.261, but I can't seem to find how.Has anyone done this? Will it work?Thanks,Dave

The call setup time is a little longger, we tried serveral methods: using terminator; adjust interdigit timeout; but didn't improve.The signaling between 5350 and PBX is pri, we use RAS. We must use '.T' because of the variable length and too many si...

Is there some secret to getting syslog started on CallManager? I have tried to configure CallManager to send errors to a syslog server (not a Ciscoworks server, just a generic syslog). I used the Alarm Configuration menu and provided the syslog ser...

On the recommendation of our Cisco partner we have purchased and implemented the following:Cisco IPVC-3511-MCUCisco IPVC-3526-GW-1P GatewayCisco Gatekeeper running on 2600 routerIf we wish to keep historical records of video calls for billing purpose...

I want to manage these two devices through SNMP, where should I go to find out if this is possible and how.The configuration document doesn't appear to helping.thanks

Hi, has anyone configure a cisco 2600 VoIP configuration using E1 CAS signaling to a PABX ?I tried to search the web, and all it has is E1 R2 signaling.Thanks

Does the Cisco 2600-XM series router support E1 CAS signalling for its E1 digital voice port or jst only support E1 R2 signaling.Thanks

I am having issues making outbound calls behind a meridian PBX. My setup is a 3540 MCU w/a GW2P gateway module. I am using the an external gatekeeper running on a 2600 with the IP/H323 IOS.. I can make LAN-to-LAN calls without any issues. The GW is r...

Guys,As to that question. I read this once on cco somewhere - that only packets that do NOT match the priority queue in MQC are subject to multilink fragmentation. Can anyone pint nme to this URL please?Thanks,Steve

I have issue like digits start with 7 with followed by 3 numbers it has to his X gateway and digits start with 7 with forlowed by 9 numbers it has to hit y gateway. i have tried different type of pattern but still i am not get through. could be plea...

Hi, I haven´t understood the concept about these ports, I want to comunicate thress offices with 1751v routers(VoIP), but in each office exist PBX, which type of port i must to use if i want to call from my phone in mi room up to the room in other ...

Does anyone know if there's a way to encode in Apple QuickTime using the OptiBase encoder in an IPTV Broadcast Server?TIADave