TelePresence and Video Infrastructure

I have been having lots of problems getting a PRI setup in the GW2P. Has anyone had experience setting up a PRI? If so what type of PRI did you order, etc? I have also been reading in the 3525 documentation to put a CSU between the telco and the IP/V...

i have 2 router 1750-2v with E&M CARD .and serial interface for lease line conectivity.each router will be in one site and will be connected to nortel meridian pbx through E&M INTERFACE AND the 2 routers will be connected through lease line.the E&M ...

Anyone know where to find information about Cisco's Cost Savings discovery methods, and/or their network savings model? I'm having alot of difficulty finding any of this information on Cisco.com.

"Ordinal 6467. Dynamic Link Library file missing MCF42.DLL.." shows up sometime during install and then the setup exits.I suspect this is caused by the chronology of software installs. What comes first? Service Pack 6.0 or IPTV Content Manager 3.4? O...

Does anyone know whether it is possible to password protect the IPTV content manager config pages? The IPTV instruction manual shows you how to restrict access to certain IP addresses, but it makes no mention of passwords! (our IP addresses are based...

How do I disable the IVR on the 3525 IPVC Gateway? I currently only have one internal endpoint with e.164 of 1000. I would currently like all calls to automatically go the that endpoint. It is an iPower 970 room system H323.Here is the route:ISDN Net...

Hi,My question is: When I use the OnDemand category, and i see the program information, i can see, that isn't in multicast range the dest. IP. It is: 0.0.0.0Why?How can I fix it?thx,Akos

I am trying to monitor MPPP link with fragmentation and interleavingusing Agilent WAN Advisor(latest v.15.0), but it seems this box can not decode fragmented PPP, so I have no visibility and right statistics of the linkand layers 3&4. Does anybody h...

I currently have 8 gateways. Three of them are connected to the PSTN the other 5 are at my offices. Each office gateway is setup with pots peers with the phone numbers at that office and a catchall voip peer using DNS lookups for routing. The PSTN ga...

I need to deploy a VoIP link over a satellite. I have used cisco before. However I need to know how Lucent's MAX VoIP solution works and performs. has anyone had the opportunity to compare the voice quality between a Cisco 5300 and Lucent MAX 6000, u...

Hello , Has anyone worked on getting a Altigen Alt Office 2 to interwork with the cisco NMHDV12 Card. Does the DNIS info get sent to the line if the controller is configured to accept the line as a T1 or should it be a ISDN PRI T1 Interface. I cant e...

While using Cm 3.2.2c and upgrading to ES 2.2.3.b I have lost access to CCMAdmin/main.asp Instead of getting the standard login pop-up window, I now get a web based Administrator access window and it does not recognize my admin password. When I try...

Hi,I am using a Cisco 7200 as a gatekeeper and I have setup a RADIUS server to log the calls. The problem is that the gatekeeper is not logging the IP ADDRESSes of the gateways (even for gateways registered to its local zone). It just logs the H323-I...

Hello,I have a situation where i want to eliminate tielines between several sites.I want to use 2600's at the remotes (there are already T1's between sites) and a 3660 at the host site. each remote has a PBX there with a free T1 (Pri I think) port. ...

Our viedo conference running on ip,but have some mosaic sometimes.The Network is: codec devices--S3524--100M fiber transceiver~~~100M fiber transceiver-S3524-codec devices. MPEG2, 3Mbps streaming,IP MULTICAST,I want to know the reason.