TelePresence and Video Infrastructure

Hello, The following error message is appearing randomly on the screens of a customer's telepresence codecs: "HTTP ProxyThe system is unable to connect through the configured HTTP Proxies" The customer is asking if a custom alert dashboard can be cre...

I need to control two CS-CAM-PTZ4K cameras that are connected to a Webex Codec Pro via a Crestron control system.The Room Navigator is able to control both cameras, however, RS-232 commands from the Crestron to the Codec Pro for CameraId 2 return "Un...

Is there a way to use a location of a presenter to trigger a camera switch with preset zoom and angle?Ask is to use a camera trigger like what is used in Presenter Track to trigger a switch to a second camera and have that camera be zoomed in to a se...

Does anyone's knows where to configure Expressway SRTP ciphers or what SRTP ciphers expressway support.Could only found SIP TLS syphers on Maintenance --> Ciphers --> SIP TLS ciphers but nothing related to SRTP ciphers. 

Room Bar setup as a personal device in Control hub will not allow sharing via the Webex App within a call. You are able to share when not in a call and you can share in a call using the Proximity App. This is the case even for the person to whom the ...

Hello,I have 2 Rooms with 2 Samsung Flip 2 and a Cisco Room Bar Pro and a Cisco Room Kit EQ.Now i have the problem that the Flip 2 wakeup the Cisco Codec every 10 minutes when the system is in Sleep Mode.If i unplug the USB Connection from the Codec ...

Moving a Room Kit Min from TMS to Control Hub. This is in a personal office, so we want to assign the device directly to the user. However, the Kit says invalid code every time we try to enter it. The unit has been factory reset. We then set it up as...

Greetings,Trying to get to the http port of an SX80 codec to reset / admin unit - Touch 10 not available.  Followed these instructions: //www.cisco.com/c/en/us/support/docs/collaboration-endpoints/telepresence-codec-c60/118576-technote-mxseries-00.ht...

Hi All  I have a project with over 200 Cisco endpoints and all of the Cisco Touch 10's are being plugged into the network (Remote Pairing)  Is there a way to be able to pair the panels to the codecs without having to go to each room with just command...

Hello - with the changes to Expressway X14.2 you now are required to have the ECDSA certificates signed.  We ran into this because we upgraded from x14.0.7 to X14.2.2 and the neighbor zones would not come up because of self signed certificates.  The ...

Greetings to all, Kindly advise if Cisco webex bar pro shown below is compliant to below requirement. Can the WebEx on barpro allow “meeting creations or creating/hosting multi vendor meetings like zoom, google, teams and skype”? Can WebEx codec i...

Can someone tell me where I can enable telnet in the web GUI of a Cisco Codec Plus?

So I have a couple of TelePresence DX80s  (and an EX90 I haven't gotten to) that I want to work with Webex. I got them because my workplace was going to dumpster them as they can't be used on our primary network. (never even used - still have the pla...