Any one out there having the following issue trying to SSH into a DX, MX, series Codec ??? CE9.1.3 version and CE8.2.3 version: I use putty and see the login: than enter the admin and right after entering password, SSH disappears ??? This is happen...
I am running VCS 8.8.2 Control and Expressway. Been working find. 99 percent of calls are H.323 calling via IP , and Alias. Sometimes the DNS works I.e XXXX@cisco.com or XXX@tryacano.com etc. Problem now is I only have a few Devices registered to ...
Hi everyone Quick question is there a license that we have to purchase from Cisco in order to use the Hollywood squares view during a call with multiple participants on the EX60?
Hi, I have a Cisco Spark Kit Plus with a P60 Camera. When the camera is connected to the Camera HDMI interface on the codec, there is no video output. The codec complains that there is no video output on HDMI 1 If I connect the Camera to HDMI 2 or ...
Dear All,I have registered cisco spark room kit plus with CUCM, but I do not see registration status and IP address of the Codec in cucm. The status is none.Am I hitting any known bug?CUCM version: 11.5.1.11900-26SRK Version: ce 9.4.0 62bc0aa4505 201...
I have a requirement to join to a webex meeting via IP phone. for that, Configured a sip trunk to expressway C which uses a different port (ex: 5564).Configured a route pattern to a test number “11111111” which transfers to expressway sip trunk.Co...
Has anyone seen a situation where IX5000 to IX5000 calls have poor video quality even though QoS is present? IX5000 to any other unit works perfectly. Also, during a packet capture, Wireshark was saying these packets were Skype packets. Is that n...
I have a problem that installation of ix5000.a customer wants know about color code of table color (basic hickory table)because he wants make a third-party table that matched color with ix5000 genuine hickory table and deploy around.in additional, we...
BACKGROUND - I am attempting to make an H323 call to an external gatekeeper that hosts calls. I currently have an EX90 registered to a VCS (version 8.11) which has a VCS-E (version 8.11) as a traversal client. I am registered to the external gatekeep...
Hello Cisco Team, I am actually facing a probleme regarding the conference bridge on CUCM. The CFB is a CMS which is registred but wthe IPV4 address is not well imported from the Trunk ( Screen shot attached). It should be ".com" at the end but not...
We have spark room kit device its a new device and when we create webex meeting device audio and video is not coming from far end. Far end participants can see our audio and video. Device is not resister on cloud we want to use this device as a ...
Dear all,i do not know my video conf auto call. Could you pls checking for me?
I have a customer that just installed a WebEx Board in their training room. In my training session with them they asked, since the screen is a touch screen, what can they use to disinfect the screen since they are a health care facility and they have...
It looks like all versions of Expressway X8.11.x have been pulled from the Cisco website, has this software been deferred? Should existing deployments on X8.11.x roll back to X8.10 or will there be a new version soon? We've got several deployments ...
I have a Version ce9.2.1.360d0bf spark room kit. I set up with H323 setting, it is available to call out and call in with polycom group 500. But it is not working with calling avaya xt5000. I can call avaya xt5000, but XT5000 call in, it will automat...
