Hello , I have registered sx-20 over MRA. In conference call change layout icon now showing on screen. So , i can't change layout. However , Other devices registered CUCM locally , this feature working properly. Regards , Ibrahim.
My office received the MX700 after we had already built our conference room. Because of that the pure size wouldn't work but we are not allowed to use anything else. My idea was to take out the primary guts and put this in a storage closet wiring e...
Hi All, Trust you are doing great, We are planning to move our TMS and TMSXE (15.) from our premises to the AWS cloud, What would be the key areas, prerequisites and dependencies to look out for, how would be ensure the connectivity and reachability ...
Hello, i have two cisco sx20 , and in my company the laptops came with displayport or HDMI for presentation...on cisco sx20 is possible to configure the HDMI2 for presentations?? on webpage configuration , i see only DVI port for presentation ... ...
Good I have a device tried to update it to a recommended version some help?
We just ran into an issue with our client this week in which all of the SX20’s unregistered from CUCM. These devices have the uri configured on the unit itself. The DX units did not unregister and they have the URI configured in CUCM. The screens ...
Hello. In my eviroment I have ExpressWay for MRA Internet>>EXP-E>>EXP-C>>Cisco UC All the users in the organization trying to connect to jabber by MRA. After the user logged in to Jabber for mobile(I see in CUCM the device is in Register mode) In the...
I need some guidance on how to programming the Touch 10 API's with Creston equipment to control the Blinds and Lights. Any starter material i could look into? Does it requires any programming on the Creston side as well? If anybody can give me any ...
In our environment only jabber is allowed. I did the configuration for SIP domain pattern.IMP domain: test.com xmpp domain: conf.test.com sip domain pattern : conf.test.com sip trunk destination: cms-dc-core.test.com incoming call in CMS : domain...
Have a request from a customer concerning connecting an external speaker to an MX300 G2 endpoint. Is this possible?
Adding a UserInterface Presentation ExternalSource with a ConnectorId of 3 will cause the Touch-10 to constantly reboot. Tested with CE9.3.0 running on an SX-20.Install Package: s52010ce9_3_0-7394032fb9c.pkg I did not see this issue with CE9.2.5 ...
There were 4 users in calls (MS Lync, Lifesize 2 units, Cisco SX 20 )The call was initiated through RMX bridge.When any participant was sharing the presentation the SX 20 was not able to receive the same.But when we do point to point call with any l...
Hello, Is there any documentation around the UCCapabilities attribut used by TMSXE to identify that a meeting is UC-enabled and therefore triggers the OBTP feature? I noticed under the reference here that the below content is generated but have found...
i can connect to CMS coSpace using USER URI PART ie auto.meet@conf.test.com.but after connecting to space, the display on top is not showing as "auto.meet's space" instead its showing as auto.meet@<ip address of CUCM subscriber> ie auto.meet@172.17.5...
Hi, We have two SX80s running CE8.3.4 with CUCM 9.1.2.13900-10. Calls are working just fine, except that we cannot seem to pass DTMF tones on any call inside or outside of our network. We just inherited support of these devices, so I am not super f...
