Hello , Expressway-e certificate is signed by COMODO . This 3rd Party CA supports MRA registration over internet ? Regards , Ibrahim.
Forum Posts
Hello , I'm looking for cisco documentation that explain SX-20 supports expressway-e registration over internet or not ? Did you test this endpoint for this purpose and do you have any document about this issue ? Regards , Ibrahim.
Hi All, I'm hoping someone can help and point in the right direction here. I am building 3 CMS servers, and am attempting to cluster the database. I have issued the CSRs based on the Cisco/Acano documentation, but when I initialse the cluster, I am ...
Resolved! vcs appliance to virtual migration
hi guys, I was hoping someone can shed some light on few questions that I have. basically we have vcs c and e 8.7.1 on appliance and its time to virtualize it. 1. I am thinking of migrating the vcs e to virtual first and next week will be vcs c...
Hi!I have Tandberg 150 MXP firmware version L4.2.I can't upgrade version L5 from L4.2. When i upgraded L.4.2 was succeed.But, If i try firmware L5 or L6 can't upgrade with message popup "System ugrade failed!".How can i upgrade to firmware version L5...
Dear all Do we have the same Certificate requirement if are using CMS with Expressway if Dial-In from external S4B client ?as we are using CMS-Core and CMS-Edge ?because I have move the config solution fromCMS-Edge --CMS-CoretoExpr-E -- Exp-C -- CMS-...
Hey All, I have found about two posts on this Subject but none of the ideas shared in those post were able to fix my issue. I'm experiencing excessive logout issues only on my VCSE. When I log in ( does not matter which browser is being used) I h...
I brought one Cisco P60 camera and the power adapter is missing. Please suggest the part number of the power supply/adapter for Cisco P60 camera
Pretty new to this product... Is there any way I can statically setup IP address on the primary ethernet port of the BE4000 Appliance, say for a out of box brand new appliance?
I am creating a driver to work with the In-Room Control API, and there is a command that i cannot find in the 9.2 API document. I am looking for an xCommand to change which page is visible. Let's say i have an in-room configuration with 2 pages. ...
Hi, I've been asked to provide a list of Jabber (movi) users and therefore need to export all user details, not including their passwords. I've contacted our system vendor and they have advised this cannot be performed from TMS and will need to be ...
Hi all, from Cisco Jabber Guest Server : "To minimize the effects of a disaster ,you must create a disaster recovery plan to minimize downtime and data loss. You can achieve this by using a VMware-supported disaster backupand recovery solution or you...
Resolved! CMS Redundant LDAP Servers
I'm trying to figure out the best way to do redundant LDAP Servers in CMS 2.3. I tried creating 3 different LDAP Sources linked to 3 different LDAP Servers but this results in errors about duplicate users. These are all the same LDAP source, just...
Resolved! TRC6 not working on SX20 with 9.2.x?
Dear All, does anyone tested the normal Remote Control with a 9.2.x release on an SX20?On our systems the Remote Control does not work with 9.2.3 or 9.2.1 - I then put back again the 9.1.4 release and the remote control worked again. Thank you. B...
Resolved! CMS 2.3 get every second following message in log "guest account manager (get), RFC822 parse failed"
Hello everybody, i have updated my CMS to Version 2.3 and now there is following message in event log: guest account manager (get), RFC822 parse failed It occurs every second as you can see in the picture. It's really anoying.. Does anyone ...
