Resolved! Cisco Telepresence SX20
Can I use Table Microphone 60 with SX20 codec
Forum Posts
Resolved! CMS License Error
Dears, I have CMS 2.1.9, I did everything right in the configuration, and my CMS is registered to the CUCM, my only issue here that i already installed the licenses to the server but i still get the license error and the server won't process any cal...
Good Morning. Looking for assistance in creating an XML Script to be utilized within the Cisco TMS for an SX20. I am looking to broadcast a message for the duration of the meeting, and thinking I can do so with an 'xCommand'. During testing I can...
We had brought Camera SX 20. During Unpackaging of the new product. We found out the Internal cable connector connecting SX20's Camera to Rotor Motor Base is broken. Is it possible to rectify the problem by either splicing the connecting tape ourselv...
Dear all, One of my customer wants to deploy a WebRTC solution. This solution should be used by external participants without requiring a client to join internal conferences. My advice was to deploy Jabber Guest. What is your opinion? Should I proce...
Hi all , I am trying to make video call between 2 ex 90 devices , both of them in the same LAN and registered in SIP to the same CUCM 11.5. The audio is working between the devices . Any idea ?
Resolved! DX80 PLAR
Is it posible to configure PLAR on a DX80 running the latest CE 9.x code? I have configured PLAR before but have not been able to get it working on the DX80. PLAR is a listed feature on the data sheet.
Hello Team , I am trying to register SX10 Device with CUCM but no luck In cucm status is unkwown and in sx10 - unable to communicate to remote server However ,I am able to ping sx10 and cucm both from switch . Can someone let meknow steps of co...
Hello, I have a big problem with my SX20 telepresence, the camera can not finish adjusting, the remote control does not work (even with new batteries). I found an error in the network interface Can you help me diagnose the problem? I guess that the c...
Hello, We have a Telepresence SX20 running ce8.2.2. A recent penetration test has highlighted an issue with CVE-2011-3188 - TCP sequence number generation weakness. I am unable to find anything that suggests that this has been raised as a bug or re...
Hello- I am trying to determine if signal degradation happens when sending full motion HD camera signal through any of the content channels on the SX80. In a nutshell, can you force 1080p60 to adequately display at the far end when sending through 1...
Resolved! DX70 - no VPN?
Hi I'm trying to setup my DX70 to connect to dCloud using a VPN. According to the instructions, once my DX70 is connected to the Wi-Fi network, I should go to Setting -> More -> VPN. However, after connecting my DX70 to the Wi-Fi network, I can't...
we are planning for CMS 1000 two numbers & Expressway to connect to outside Need to know what is the internet bandwidth required for using the CMS 1000 on full capacity ? Per call how the bandwidth usage ?
Touch 10's connected to Cisco video codec systems running newer CE9.x firmware have a funky background where large color balls float in and around the Touch 10 display. Is there a way to disable this feature?
Hello, Within TMS for the TANDBERG MXP there was an option for 'OSD Menu CodecLabel' which allowed the Administrator of the unit to have a permanent label showing on the CODEC -- whether the CODEC was in a call or not. We used the option as our CO...
