Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,
I'm encountering an issue on CISCO Tandberg C20 that I have upgraded from TC5.4.x to TC7.3.5
The endpoint is working properly, except I can't ping it, I can't access it through Web,Telnet or SSH.
Any tips to resolve this issue, guys.
...
Hi,
I need to integrate Active directory to VCS-C (Expressway C) . I can't find options like Configuration --> Authentication--> Devices --> Active directory services .
I am seeing only Configuration --> Authentication --> outbound connection creden...
Hi All,we have just installed MX800 for use with existing UC infrastructure.i'm trying to figure out how to join a WebEx meeting. I can call the WebEx dial in number but I only get audio. MX800 is registered with CUCM 10.5.1. Your help will be greatl...
When creating conferences on the MCU, We would like to setup a weekly conference and have a randomly generated Pin each week the conf is held. I can see nothing on the MCU itself. Is their some plugin or 3rd party way we could do this?
While doing a routine check of a conference room a TelePresence camera was found to be radiating a strong 200 kHz wide signal at 556.9 MHz.
This was unexpected and a bit alarming. Inspection of the camera did not reveal any circuitry alteration. ...
What is the recommendation of registering MX300-G2 over the Internet as there is no dedicated circuit from MX300 site to the UCM.
We have UCM 10.x and VCS C/E
Hello guys,
I'm deploying an Expressway solution version 8.7, using two different domains.
For example I have my internal domain lan.example.com and my external domain is example.com.
My problem is when I try to log in using Cisco jabber using ...
I've been running a UCM environment for some time now (Recently upgraded to 10.5). So far, I've been lucky enough to have remote offices with decent bandwidth so I can get away with g.711. I now have a site on a cradlepoint and need to implement a ...
Hi
I have a MRA deployed with a pair of Expressway Core and Edge.
I want to enforce a policy that would not allow the user to dial any number starting with "9" when the user is out on internet (via MRA)
The same user when on the internal network wi...
Hello friends.I have one situation, i need transport one TDM circuit from one POP ( point of presence ) to a remote POP via sip. i'm used two cisco 2801 with E1 card.Below a picture of scenario.
I'm need to forward all calls from Local POP to Remote,...
Hi Guys i need help in desperate situation , my problem is i am not able to forward calls to client cell phone , This is not it goes when someoen calls on clients E.164 number the call does not forward to cell phone at at it gives fast busy tone ...
