Hello Everyone,
is there anyway to disable the yellow Bar "Previewing Input X" when previewing and not sharing any content on a SX80.
I feel, like I've read the whole manual now ;)
Thanks in advance.
BestsMax Welskop
The "CTS-PWR-AIR-INJ5+" can be ordered when we purchase CTS-CTRL-DVX-10 from Ciscoand the "CTS-POE-INJ" can be ordered when we purchase the CTS-SX20-PHD12X-K9 from Cisco both of them are used by the Touch 10 (CTS-CTRL-DVX-10) for the SX20what is the ...
Hi folks,
Our Crestron programmers are seeing very slow response via RS232 after upgrading from TC7.3.x to CE8.0.0, like 30 seconds between button pushes. I looked for release notes on CE8.0.0 but didn't see anything on Cisco's software download ar...
I have an MX700D with SpeakerTrack. It is at a remote location.
Apparently the end user used the controls on the Touch 10 to disable SpeakerTrack - it's not zooming in.
Is there a way in the web GUI or command line to check and reenable this?
I am trying to add a Polycom VSX8000 to our TMS version 14.3.2 - I keep getting the following error: description: Send command 'volume get' failed, base exception: Send failed for host
I have added other VSX8000 units without any issues - any informa...
I have (3) hardwired Cisco table microphones connected to a SX80 codec.
On 2 out of the (3) microphones the MUTE state is not in sync with the Cisco touch panel mute indicator, the 3rd microphone is in sync with the TP.
This condition is only happeni...
At our college we have one SX80 as lecture origination and three SX20's at satellite campus locations running TC 7.3.3 registered to CUCM 10.5. We use conductor/telepresence server for bridging and TMS for scheduling.
Is there a way for our instruc...
Hi All,I am having difficulties to setup the conference layouts. My customer needs two thing1) While presenting something, the contents should be fullscreen in all participant and when participants talking while presenting, the ActiveSpeake should no...
Hi Experts,
We have a project consisting of AV systems with control system using Crestron and videoconference system using SX80 codec. The plan is all controls will be done using the Crestron with its touch panel for centralized control system. Audio...
HiOn one of our CTS-1300-65 I´ve recognized a red x at display status, but there is no issue and the status seems to be ok:Displays StatusVideo cable: OK; Power Cable: OK; Display Diagnostics: OKDisplay_SerialQCI13179086Display_Hardware_ver1.3...
Hi All, Is it possible to schedule internal devices registered to an internal TMS to dial to an external MCU meeting room? If so, how would one go about doing it?
Hi;
We have both SX 80 and SX 20 VTC units and would like to share resources during a call by using a MAC mini which is recognized by the CODEC as HDCP source. Therefore, it doesn't pass the signal through the CODEC.
Is there a work around for thi...
Hello, is it recommended to disable any type of H.323 or SIP inspection on firewalls to avoid packet loss, latency or jitter for videoconferencing applications?
Hello fellas,
I have a problem with a mic´s SX20:
- The mic is unmute (green light), so when I push mute button this keep unmute (green light)
- The mic is mute (red light), so when I push mute button this keep mute (red light)
But I could change...
