Hi everyone, I have a Cisco camera, model CTS-CAM-P60, which I’ve connected to my local network. It’s now assigned the IP address 172.16.0.27. I’m trying to control the camera independently, without connecting it to a Cisco codec. Ideally, I’d like t...
Forum Posts
I have an old DX80 that doesn't respond to finger touches. I performed a factory reset but that did not resolve the issue. Can I reinstall the firmware from a USB stick in hopes that this might resolve the touch screen not responding to finger touche...
I have consumer televisions connected to a Cisco Codec Pro with CEC enabled. When the codec is in standby mode, the TVs will wake up (with no signal) because the codec is checking the status of the TVs. I know this is a problem with the TVs misinterp...
Hello,I have several Cisco video conferencing systems, and the Navigator tablet is missing the keyboard for my region, Switzerland.More precisely, the Swiss-French keyboard.It's a rather specific QWERTZ layout.How do I add this layout?Thank you.
EIDT, this is for the WebEx platform. When an attendee mutes themselves, they retain the ability to unmute at will. The picture shows three attendee microphones, with the top and bottom mics only allowed to unmute when requested by a panelist. The ...
Hello,I’m encountering an issue when connecting my MacBook to a Cisco Room Bar using a USB-C to USB-C cable.The Mac detects the Room Bar correctly.Screen sharing works as expected.The Room Bar’s camera and microphone also work properly.However, there...
GreetingsI have followed the script that was posted on GitHub to create a Report an Issue button on the Touch 10 that integrates with ServiceNow to create an incident ticket I have the macro loaded but I keep getting the error: URL not allowed by rul...
Good afternoon,We are trying to create a button that helps us display a URL both on the touch screen and on the television. The script is as follows: const config = { button: { name: 'Web View', // The main button name on the UI and its Panel Pag...
I have a couple Cisco Room EQ Kits being controlled from an Extron IPCP processors with Rs-232 to USB-A cables. We have two rooms with the same setup that are having issues with the Rs-232 communications failing after a certain amount of time. Is ...
Hi everyone, I've been trying to set a layout on a Room Bar Pro where we have the main camera as the primary image and then use the following xCommand to set a HDMI camera as PIP. I'm finding that the command takes but on reboot its dropping the se...
I am experiencing the issue described in CSCwo61235 in the field, but my device is not registered to Webex Control Hub and is instead used as a standalone Microsoft Teams Room. Because of this, I am unable to access or pull down the necessary softwar...
Hi, I am designing a VC solution for 25 pax meeting room. In which i am proposing Cisco Room Kit EQ with Quad Camera and PTZ4K for extended speaker tracking. 1. Speaker Tracking or Extended Speaker Tracking works with 3rd party Ceiling or Table mics....
I am interested in using the room kit for digital signage. We'd put 50-100 of our company photos somewhere and the kit could play those photos when not being used. Videos would be cool too, but not a requirement.My understanding is that the kits aren...
Hi all,We have a Cisco MX700 telepresence system that has been deprecated and disconnected from Cisco Services due to end-of-life. The system worked peefectly before Cisco decided to remove it from its services by software. I have tried to connect it...
Hi AllHow can reset counters Status-Overview-Resource Usage without restart servers?
