TelePresence and Video Infrastructure

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Resolved! How to remove Macro and In-Room Control via provisioning?

Hi, I have a question: We are using "xCommand Provisioning Service Fetch" for mass provisioning of Macros and In-Room Controls. This works as expected. Now we have the need for removing some of the previously provisioned Macros and In-Room Controls. ...

Cisco Panorama Room Kit Macro - 'Unhandled promise rejection' { code: 1, message: 'No available http connections' }

I have a small macro that is supposed to interact with a Philips Dynalite via UI extensions. However, while writing & testing it, i repeadeatly ran into the issue in the title. Are there any sort of limitations on outgoing API HTTP requests, or do i ...

pescla by Beginner
  • 363 Views
  • 0 replies
  • 0 Helpful votes

Resolved! Does the cisco webex room kit allow HDMI signal pass-through when not in a call?

Hi, Does the cisco webex room kit (regular) allow HDMI signal pass-through when not in a call? We are thinking of routing the user HDMI through the codec for the only connection to the TV. So user would not initiate a call on the codec and still see ...

mstork by Beginner
  • 868 Views
  • 2 replies
  • 5 Helpful votes

Resolved! Webex Room Kit & Kit Pro RoomOS 10 Firmware?

Hi,We have three CS-KIT-K9 and one CS-KITPLUS-K9 that we want to upgrade to latest release of RoomOS 10 (RoomOS 10.3.1.2 a911d5664c8), but I can only find CE9.15.0.13 in Software Center?Where can I find the latest release of RoomOS 10?Thanks!Best reg...