TelePresence and Video Infrastructure

if so, what are the pinouts for the EX90? (TX/RX/GND) The AMX uses pin 3 for TX, Pin 2 for RX and Pin 5 for GND. I have been using an RJ45 cable and trying to match pins but I am still not getting a TX signal. Also, does the COM port need to be enabl...

I am using EX90 with TC 7.1.4, my issue with camera which display my image on opposite side(upside down) even when I make a video call the other party will see my picture reversed upside down but I can see his picture fine.

Hi All,We have Below scenarioSX20----> MCU<----- PolycomSX20 -----> PolycomIssue: When we make a Call from SX20 to Polycom IP to IP call or even using MCU Cisco SX20 gets disconnected after fixed interval ( 15 - 20 minutes)Calls from Other endpoints ...

Hi All,We have Below scenarioSX20----> MCU<----- PolycomSX20 -----> PolycomIssue: When we make a Call from SX20 to Polycom IP to IP call or even using MCU Cisco SX20 gets disconnected after fixed interval ( 15 - 20 minutes)Calls from Other endpoints ...

Hello,I have a setupEX90 --- SWITCH --- FIREWALL --- INTERNETI am using direct IP call without VCS. When i dial to public IP of video conferencing i can see call connected and no video receiving on my EX90, but on EX90 touch pad i can see "only outgo...

We are having VCS control and expressway physical appliance running X7.2.2.Do we have any limitations in upgrading the software to the latest X8.5 in appliance?Are these platforms supported for latest versions of software ?Thanks in advance. Mathew  ...

How we will check warranty status check, please send me link .

Regarding the C series codec installation, we need to install the codec on the equipment rack and camera will be place 40 mtr far from the equipment rack, So how will use the HDMI cable and control cable. Cisco have any special HDMI extension and con...

Hi,  We need to setup a VCS Expressway cluster.  The currently there is a single VCS Expressway setup and we are going to create a cluster and add in the first peer.  Typically, the LAN1 is Non-NAT interface and the LAN2 is the NAT interface.  Howeve...

Dear Community, In order to activate AES encryption, how to get the Key? kind regards

Hi, I am in the process of configuring Expressway MRA for a client that is also concurrently using VCS C&E for B2B. The issue I have is that the MRA documentation does not clearly state if the _SIPS SRV is required for MRA expressways if you are NOT ...

This is regarding how to add route in VCS expressway through CLI I tried commands starting with x but it is not taking  command which i tried : xCommand RouteAdd Address: "10.13.8.0" PrefixLength: 32 Gateway: "192.44.0.1" Server is not accepting the ...