TelePresence and Video Infrastructure

VCS Control Running 8.1Codian 5320 MCU   running 4.4(3.42)CUCM running 9.1 EX90 running TC5.1.5.297625 SX20 TC6.2.0.20b1616EX90 & SX20 > Registered to VCS8945 > Registered to CUCMMCU is registered with CUCM and VCS both.When i initiate a multiway cal...

Hi Guys,we are experiencing a problem with inbound calls on a ISDN LINK paired with a sx20 telepresence codec.Release software used are: SX20: TC 7.2.1ISDNLINK: IL 1.1.4ISDN connectivity is provided by an E1 PRI channel.Description of the problem:Inb...

Hi there,I want to make a demo with one MX300 G2 and MX200 G2 for a customer.I want to use both endpoints in a standalone mode, the customer doesn't have any vcs or cucm. ( Point to point call);I read in the following thread that i must use H323 to b...

Good EveningI using the internal address book of SX20.I know how to remove and how to add data to the address book.(I use the API command)However, after I have deleted the data that has been registered in the address book, number will continue to be ...

Dear All,I have an authentication fail issue during endpoint sip registration to VCSC.VCSC event log say that user not found. But user was created in VCSC local database and that user credential is working for h323 authentication. On endpoint system ...

Where can I find the API for a cisco CTS-CODEC-PRI-G2R  (Tx9000)

I've come into a new environment with my new job and noticed that the TMS server has TMSPE installed, but when going to TMS general settings, I don't see the right dropdown. I only get Enable Cisco TMS Agents. I am on TMS 13.2 (looking to upgrade to ...

Hi,I have added 4 of my Polycom HDX 8000 Series to a TMS.The Trial TMS version being used is 13.2.2The Polycom HDX is running 3.1.3 I wanted to understand in detail as an end user of TMS, what are the functionalities in HDX that I can expect to manag...

Hi all,Right now we're running TMS 12.6.2 and going to update to 14.5.Our 12.6.2 Version is running on a Windows Server 2008 R2 (32Bit), we want to make a system upgrade as well and go to Windows Server 2012.My question, probably a little funny, how ...

In a scenario i have 1 publisher and 4 subscriber and 1 Moh server. It is a distributed architecture( IMAGE ATTACHED FOR REFERENCE) .1. Pub , 1 Sub and Moh servers are installed at a single location connected to DMZ switch.2. Similarly Sub 2, 3 and 4...

Hi all, We are planning install Cisco TelePresence Server MSE 8710 for our customer.we haven´t install this equipment, then we need know if is possible install the Cisco TelePresence Server MSE 8710  standalone, like a MCU, without a CUCM or VCS. Reg...