We would like to connect three new Cisco C60 units to an existing ISDN gateway. The Tandberg Gatekeeper TTC2-01 REV.2. are these devices compatible? If so is any specific configuration necessary?
I am using TMS and setting up a conference with 2 internal endpoints and trying to add a third remote (traversal via VCS-E) by dialing the IP address only.Conductor is used to setup the bridge call to MSE8000 8510 blade.In TMS Conf Ctrol Centre, when...
Hi,we are analysing Lync Server 2013 and Cisco IM and Presence environments and I lack informations which are not in Microsoft Interoperability guide for VCS. I know that Lync uses different codec for video than Cisco. I want only 1 platform, not bot...
The ISE ERS endpoint java demo downloaded from Cisco does not deregister the endpoint. The output is:################################################################ De register endpoint: ## This demo sends PUT...
I got the error message when I open the TMS users button, this seems to be DB user table got problem.What can I check from the TMS and SQL DB?the TMS version is 14.3.2 the detail error message :
Hi,We've got 2 TMS servers running 14.3.2 software behind BIG-IP load balancer. We're going to upgrade to 14.4 but Cisco has changed the redundancy model from active/active to active/passive. Some changes are required on the load balancer and this is...
Hi, all.I have a question about Cisco TelePresence SX20, with firmware TCNC7.1.1.168aadf. This firmware may use LDAP as server for Phonebook? I can see only: VCS, TMS, Callway, and CUCM. May be another version? Thank's
I have a client reporting that their c40 running TC7.1.1 is having an odd issue when sharing content locally. They have a dual screen setup, and often share content to their room on both screens outside of video calls. The left monitor which is what...
Hello,we have recently bought Cisco EX90 with software version TC7.0.2.aecf2d9. We are facing a problem with presentation sharing. When we make a video call and start presentation sharing call suddenly drops. On other side is also Cisco EX90 with sam...
We have customer with SX20 on a private network IP address in their remote office that had a 8" Touch panel paired on the same subnet/switch. They now have moved the SX20 to public IP address (still connected to same switch) and want to pair the 8" ...
Hi all,I’ve a customer with an old videoconference device Tandberg 800 with 3 BRI access that have the following problem:When i make a video call to another end-point by ISDN , the video call establish but then is always intermittent , one moment I’v...
hi All,I would like to have a spare DVI to VGA presentation cables for SX20, I managed to searched the Part number is "CAB-DVI-VGA-3.5MM - SX20 3.5mm", but I cannot confirm, because I suppose the cable should be shipped with SX20, when I created a BO...
Hi,Have a customer who advises as per the discussion title :-When trying to project video from their Win 7 laptop, the CTS1300 TP unit states that the resolution is too highIt has worked fine up until the upgrade to Windows 7Customer advises colleagu...
Good day all,I have a customer who is wanting to upgrade all of their VC and WebEx SaaS infrastructure and to enable the CTS enabled WebEx.Does anyone know the SKU for engaging Cisco Advanced Services to perform the A2Q and to assist with the integra...
Not using clustering. A single (tier 0) instance of TMS exists where all jabber video accounts will be created (divided into folders that correspond to each VCS control). Will this single instance of TMS be able to provision all 10 individual VCS C...
