TelePresence and Video Infrastructure

Hi I have configure and heterogeneous conference bridge on an ISR G2 router (PVDM3-256).I have configure 3 video class , ulaw, CIF and H.264 codec only.I can conference 9971's and 9951 video phones but if i try to add a EX60, The EX60 gets only audio...

Hi all,  So we decided to  upgraded the router and i went with upgrading the CME to 8.6 from 7.0.. running the recommended IOS 15.1-4M, the config was the same nothing changed, however we get no caller ID, i know nothing was changed on the carrier si...

We are upgrading our SX,C and EX Series codecs through TMS software Upgrade option and all the Upgrades seem to fail with HTTP 400 error code. We have been doing the TMS based upgrade for TC5 and TC6 with no issues, but facing an issue after TC7. Any...

Hello - We are running Cisco TelePresence Content Server (TCS) v5.3 on G2 Platform and find the quality of Presentation on a Live Stream is very poor. In other words we don't find the clarity and sharpness of the Presentation preserved after the TCS ...

Hello everybody, yesterday I updated two VCS-Control and two VCS-Expressway. One pair from X7.2.2 to X7.2.3 and one from X8.1 to X8.1.1. On the VCS-Control everything worked fine, but on both VCS-E update I ran into "problems":The Update cleared some...

Hi all, just configure a cisco cube. Incoming and outgoing calls working fine till now.Just facing an issue by outgoing calls. Any call will display the sip-ua registered number. Is there any possibility to send the invite with the calling extension ...

Hi, i have a cisco router 2921 with voice licence and i want to configure SIP trunk with my provider. the configuration is next:voice service voip no ip address trusted authenticate address-hiding dtmf-interworking rtp-nte allow-connections sip to si...

I've a customer who upgraded their VCS cluster from 7.2 to 8.1.1, and now 1 of the 2 expressways in the cluster is behaving oddly.The web interface of this expressway is very slow to respond.  "Every click is followed by a 1-2 minute wait".The other ...

Hi people,I have a big problem here and I don't know where I start to solve this issue.Topology: Company A has 2 building and 1 VCS that works for both building. Company B has 1 building, 1 VCS, 1 TP Server and 1 MCU CodianBoth VCS are connected thro...

Is there a way to connect to a Touch Panel 8 for remote control?The issue that I am trying to solve is that the Touch Panel may become unpaired to the C20 codec during a software upgrade and I want a way to "touch" the panel remotely to tell it to re...