TelePresence and Video Infrastructure

All,I have noticed on several TMS deployments that TMS keeps pushing the IPv4 address to all the endpoints for their Phone book server 1 URL field, instead of the FQDN.I have verified that under Admin Tools, Network Settings, Advanced Network Setting...

Project Workplace is a guide to finding the best solution and best practise set up for TelePresence rooms, including guidelines for microphone setup, lightning etc. http://www.cisco.com/web/telepresence/projectworkplace.html In this release user s...

When selecting Presentation it appears the C60 is overriding the Codian MCU layout and displaying its local layout. However, when selecting a camera source the C60 displays the layout selected on the Codian MCU. Is this normal or a bug?Sent from Cisc...

hi i have an implimentation 1vcsc and 1vcse in dmz.i configured  sip and h323 and both are active in traversal zone.and i regisered 1 polycom end point to vcsc and 1 polycom end point to vcse.but am not able to make a call between them. i tried both ...

Is anyone aware of a log anywhere that tracks changes made to individual an codec's configuration settings?    The codecs are managed by a TMS system.  

Hi,One of our clients using Cisco MSE8000 MCU with 30 port 8420 media card for vedio Conferencing for different remote Intranet locations. How can i check Vedio Latency at remote Locations where Camera has connected ?Plz explain with Commands and sim...

Publication date: 2013-05-23Author: Kjetil Ree, Cisco CIBUProducts affected: Cisco TMS 14.2.0 and 14.2.1CDETS ID: CSCuh09140Problem DescriptionA defect (CSCuh09140) in Cisco TelePresence Management Suite 14.2.x could severely affect customers and pro...

  I have a Cisco Intouch 8 panle that has the exclaimation mark on all the time , and it does not boot up. I have tried rebooting it , and also tried completing the factory reset of the endpoint however it is still showing the exclaimation mark indic...

I have multiple endpoints registering with the VCS control unit however when they are making a call they are using the Non-Traversal licenses. Is there any way that I can get the endpoints to use the traversal licenses

Hello,I am pulling CDR reports weekly and noticed that after about 4 months back TMS doesn't show any report data.  I looked around TMS settings but couldn't find a selection where this is set.  I was curious if I am just missing it, or if this is de...