TelePresence and Video Infrastructure

Hi All,We have one c series endpoint with ISDN link. How can I dial a audio call from C -series endpoint. Currently we are able place video calls to other video endpoints, but calls to telephones/mobiles  were not going.Please guide me is there any s...

Left work Friday afternoon (May 24th) - TMS showed correct service contract status for all systems; arrived at work Monday morning (May 27th) and TMS now shows incorrect service contract status for 72 systems, showing "No contract" for the majority o...

Hi All,Anyone know if there is a way to have scheduled conferences with multiple parties auto extended if only some of the rooms are still available. The default behaviour seems to be to stop the conference in its entirity, even if only one of the ro...

Hi,In a way of configuring a new VCSc to an existing old Tandberg Gatekeeper, running ver. 6.1. (Later to be replaced of new VCSe)So far the VCSs(verX7.2.2) is to be working as an transcoder for SIP- H.323  between the CUCM(Ver.9.0.1) and Gatekeeper ...

Hello,I have been having issues with my C40 that goes into boot loops.I have not been able to access it from neither web or ssh, only serial connection.I have tried to load new software to it (twice) as the flash did not have any valid kernel image, ...

Hello everyone,I've got a strange license issue on a virtual VCS installed on a BE6K:I've got an endpoint registered both in H323 and SIP on the VCS (7.2.1) and a Cisco Jabber for windows registered on a CUCM (9.1). CUCM and VCS are linked by a SIP t...

Hello all,I think I have a simple question. Is it possible to administrate with an TMS 13.2.2. my new delivered C40 codecs with software release 6.1.0.Thanks and best regardsMatthias Flunker

HiI'm currently testing a setup where we have a TX9000 calling directly to a VCS registered EX (also C20s).  The quality of the direct call between the TX9000 and the EX / C20 is visibly poorer and in 4:3 format compared to when the call is bridged v...

As per the title, is it possible to hard set the MTU on a VCS-C/VCS-E?  I know you can enable RFC4821, but I'm not sure if I can have a hard set limit...