TelePresence and Video Infrastructure

Hi,I have recently upgraded a C20 and EX60 to TC6.0.1 from TC4.1.4 and TC5.1.4 respectively. As per customer requests, I was then ordered to have them downgraded to TC5.1.5 for both units.After the downgrade, I am unable to access the web interface f...

I have problem with MX200 audio output quality. After we installed MX200 on the table, we realized that the audio output is somehow in and out.  The level of audio is not consistent.  Some time it is at the right level, and some times it is very soft...

There is one article on community about this topic. Someone try to integrate CUCM 8.6 with VCS Expressway for direct video calls from Jabber for Windows? or calls from Cisco Codec such as EX60 or C40 registred on VCS-e?Please get advice about this in...

Hello everybody.I found on the cisco pages the Crestron-macro for controlling C-Serie  ( Tandberg_C90_C60_Serial _v1_3 )I want to ask if, there is a newer macro available on the net, spezially i´l looking for phonebook adding and modifing contacts on...

TelePresence v1.7.4 with CUCM 8.0 introduced QoS settings for CTS endpoints.  From what documentation I have found...CTS SysOp messages would display a change...but the SysOp messages are only available via CTS endpoint GUI (as far as I can tell).  Q...

Hi,does somebody know if NAT on a EX90 can be configured with a dyndns name instead of an IP address .. I have the challange to connect a EX90 directly behind a DSL router which IP changes once a day. I configured the router already and have access t...

I've connected a PC to the PC port on the EX90.  Is there a command that I need to use to activate the interface (internal EX90 switch)?  I've changed the voice_vlan_id to the correct number and set the voice_vlan_mode to 'auto'.  But those settings ...

                   How do you wipe the configuration on a VCS or VCSe? Im not finding it on the documentation and I need to factory default one.

Hi-I'm seeing some strange behavior from my TCS', it doesnt have happen all the time and not on all boxes. Some recordings will transcode at a much higher bitrate than others.  All the aliases are set to the same template and output type, MP4/Medium....