Hi!What is the reason why the VCS running findme also has to run the presence server.With the combination that there shall be only one presence server for a specific domainand the need that a domain has to be added on the presence server, authenticat...
Dear Team,We have an MXP edge 95 with ISDN BRI Line connection, Here when we connect the call after 5-10 minutes the call gets disconnected.Currupted Data Recieved message comes.and also on diagonostic page during the call, Frame Loss Total & Capabli...
Need advise on how to convert a SIP call to H.323 call.I have a SIP incoming call to VCS-A and I would like the VCS-A to send the call to VCS-B as a H.323. Can this be done and how?Thanks,Khoa
Hi All, I have a a problem with the LDAP connection of the VCS control.As far as I have configured everything in the lab with the port of 389. That works fine.In another case at my customer, I need to use the port 3268. The LDAP connection is g...
have the software ruinning in basic mode on my windows 7 pc also have a cisco camera on the network,I can get bthe monitor to know it is there, but it doen not connect.theyb are on the same subnet and there is just switch ports between them.what am I...
ON the EX90s, when I select the Cisco VCS as teh Infrastructure option, it prompts me for UsernamePasswordDomain and External Manager.What username and password is this trying to authenticate against? Where is this configured? IS this done in TMS? I ...
With VCS cluster implementation, there are four options for endpoints to connect to a cluster: SIP Outbound (preferred), DNS SRV (2nd choice), DNS Round-robin, and Static IP (lease preferred). I’m using option 1. With option 1, an EP register to ...
Dear Forum!I'm facing the following issue. One of the older C20's is configured to register to a gatekeeper using a specific domain, which is equipped with the appropriate srv records (h323rs, h323ls and h323cs). The C20 is running the version TC3.1....
I'm curious how much effort is made to test interoperability between Cisco and Polycom. I cannot be the only one that dreads troubleshooting interop issues in the telepresence community. I know that Cisco will help me as far as they can on the cisc...
I am creating an order for a CTS-P55C40-K9. My client has listed the following options as what they would like.Software 5.x EncryptionCodec C40 buried optionInTouch 8 + PID for ServiceDNAM III buried optionPrecision HD 1080p 12x unit + auto expandPr...
Hi I got a temprature issue at some Codec`s C40-C90.try to do the xstat sys comand:xstatus SystemUnit Hardware Temperature But only got: xstatus SystemUnit Hardware Temperature*r Status (status=Error): Reason: No match on address expression XP...
Hi All,I am not very familiar with Cisco VCS and TMS solutions. Are there any good documents which i can refer to understand architecture/functioning of these solutions?Also, I need to integrate few SX20 with VCS and TMS. I am unable to find integrat...
