TelePresence and Video Infrastructure

hello all, i have now encountered this issue 2x in 2 seperate customer environments.  the promlem i am having is getting video to pass between CUCM and VCS when CUCM is on version 7.1.5.  i have built a sip trunk according to the Cisco config guide (...

Hi.Two quiestions:1. All our video terminals are widescreen, and then you use MCU streaming, you get 4:3 video streamed, cut left and right borders. I did not find corresponding option in settings. Any suggestions?2. Is there ability to connect to co...

Hi ,I just wanted to know whether there are two different authentication credentials for XML- RPC call and for CLI access ?I cant get this info in docs which i have.Regards,Shankar

Hi,I've a problem using a TouchPanel paired to a C40 TC5.1 (issue also present in TC4.2) when I try to call to a contact (IP) shared by TMS (13.1).C40 is registered in a gatekeeper (gatekeeper mode), once I press over 'Call' an error appears:Cannot c...

Hi,I'm tasked with setting up a demo environment on a production client's network, we will just install 3 end points, most likelly SX20s for ease of deployment, my question is:What is the simplest and most effective scenario to deploy the units?They ...

I have a Tandberg 6000 Classic running E3.4 software, I know its very old.....We are working to get the system replaced with a C series Codec, but in the mean time we want to have the 6000 use the TMS Corp Dir phone books.We had several classics on t...

Do the C-series codec have the ability to switch camera preset based on microphone level? For example when mic 1 is receiving the strongest audio level then the preset 1 is activated, when mic 2 is the strongest then preset 2 is activated.           ...

Hi eveybody,I am to a customer and I meet this error when I try to install a TMS software on a VMWARE ESX :Someone can help me plz

Hi all,As recent trend of CUCM & VCS integration, our office has followed the same to build a SIP trunk betweem CUCM & SIP. I have checked IPphone from CUCM side can call to video endpoint successfully, but there is loop detected on the call from vid...

Hello,we would like to test the integration between VCS X7.2 (VM version), CUCM 8.x and Microsoft Lync 2010, by only using the VCS demo licenses (for CUCM and Lync, we already have "real" licenses).Is it possible?TIA and regards.