03-16-2016 10:40 AM - edited 03-18-2019 05:42 AM
Hello,
We have several endpoints registered with CUCM 9.5. We also have a legacy Tandberg, probably 7 years old located on one of our WAN sites (connected via leased line) that we want to call and receive calls from by IP. We do not have any MCU or other Voice products, only CUCM.
I have been searching for examples but since I am very new to this subject I would like some help from experienced forum members. From what I understood, to call a registered endpoint from the unregistered one we should dial the ext@CUCMIP, is that right? What about dialling the IP of the legacy unregistered Endpoint from the registered endpoint?
All help is appreciated.
Regards
Moe Shea
Solved! Go to Solution.
03-16-2016 01:32 PM
You would need Expressway-C/E to be able to call the endpoint. CUCM doesn't support IP address dialing, but using an Expressway-C/E you can, see the Dial IP Addresses from Endpoints Registered to CUCM with VCS / Expressway Configuration Example.
03-16-2016 01:32 PM
You would need Expressway-C/E to be able to call the endpoint. CUCM doesn't support IP address dialing, but using an Expressway-C/E you can, see the Dial IP Addresses from Endpoints Registered to CUCM with VCS / Expressway Configuration Example.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide