Cisco Meeting Server 2000

[Bridgesj]

Not getting acano> prompt when logging into the MMP for the first time.

Assigned ip to the CMS200-MMP-CIMC ip-pool (block), however when I SSH, I am met with;

Cisco Serial Over LAN:

Close Network Connection to Exit

No acano> prompt for further configuration.

[Patrick Sparkman]

Have you double checked that you've configured the UCS correct in section 3 of the CMS 2000 Install Guide?

[Bridgesj]

Yes, I have assigned IPs all in same subnet

UCS-A 172.16.1.10

UCS-B 172.16.1.11

MMP 172.16.1.12

Powered everything on and set interface speeds.

Able to get to the MMP but no acano> prompt to facilitate any syntax.

I have access to KVM and BIOS, but not seeing anything ill configured.

How is CMS2000-MMP (vif/vNIC) configured in UCS Manager?

Is there a way to restore back to factory settings anb start config over?

Is there a way to confirm that the acano firmware/software is even present?