01-14-2016 10:57 AM - edited 03-18-2019 05:25 AM
Hello.
How do I remove the 'No camera connected' warning message from the on screen display?
I am using input 4 and I don't need the camera.
Thanks again!
Solved! Go to Solution.
08-23-2019 01:06 PM
06-19-2019 02:18 AM
Would also like to add that this is the correct answer to this problem, with no extra screen workaround required!
06-19-2019 12:56 PM
You can't, only the original poster can choose the correct answer. This thread is three years old, the answer then was the correct answer then.
09-14-2019 08:48 AM
That did it !
Thank you.
Log in to the codec.
(you need the IP address, username / password)
Go to:
Setup > Configuration > Peripherals > (in the “Profile” area, set “Cameras” to 0.
Press “Save” on the top right of the screen.
Message went away.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
