cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
78
Views
0
Helpful
0
Replies

Codec Pro Control

johnmikel
Beginner
Beginner

I am working on a job where a consultant specified third party control through the Touch10 port on a Codec Pro.  Is it possible to change the IP address on that port (or any port other than the LAN port), or are these hard coded to 169.254.1.1?

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers