05-18-2015 12:57 AM - edited 03-18-2019 04:29 AM
Hi
I appreciate a configuration that permit clone screens connected to HDMI 1 and 2 on a SX20.
Activating Dual Screens on Monitor permit use both screens independently, but I need screens shows the same on both.
I trying different combinations unsuccessfully.
thank you for the help.
Best Regards
05-18-2015 03:59 AM
Have you tried setting Video/Monitors to "Single" ?
/jens
Please rate replies and mark question(s) as "answered" if applicable.
05-18-2015 05:50 AM
Hi
Yes, I set Monitors to Single and use HDMI1 and HDMI2 on first both or first/second but second screen on HDMI 2 doesn't show anything.
If I set monitor to Dual, it doesn't care if I set HDMI1 and HDMI2 to first o Second, HDMI 2 is always as second screen, not clone.
Thank you
Best Regards
05-18-2015 05:21 PM
I just tested with a C20, and was able to duplicate the HDMI outputs by setting.
Configuration Video Monitors: Single
Configuration Video HDMI1/HDMI2 MonitorRole: First
The OSD will not be duplicated, it will only show on one screen only always.
As I just tested, it should work, but there was another post a few months back someone else suggested to use the following, and they reported back that it worked for them.
Configuration Video Monitors: Auto
Configuration Video Output HDMI1/HDMI2 MonitorRole: Second
05-19-2015 07:25 AM
Thank you for the answer.
I will check.
Best regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide