Converting TANDBERG T3 LR units over for stand alone operation

[kylevt771]

Hello ,

I opened an earlier conversation about only placing audio calls on some units I have. I have since discovered that they are the left and right units from a T3 system and are licensed as such .

I would like to reconfigure these units to work as stand alone units and I am wondering if anyone has any experience with them .

Thanks.

[Patrick Sparkman]

Found this discussion searching the forums, t3-c90-codecs.  Looks like you might be able to do, but would need to contact Cisco to do so.

[kylevt771]

Yes , I have the T3 LR"Option" installed . I am wondering if I can just remove that if it will just go back to normal. 

I thought you could back up all your release and option keys . 

[kylevt771]

Just an update on this.

Removing the option by itself did not work (Naturally) . I have a case open with cisco to try and remedy the situation and am hoping that just going back to regular ole C90 doesnt mean I have to buy regular licenses .

Now , if 1P005 - Product Key T3 Center
1P006 - Product Key T3 LR is the part numbers for the T3 .Does anyone know the part numbers for the "Tanberg c90" product  key ?

[kylevt771]

You dont happen to have access to a C90 and would be nice enough to pull the TC console configuration file from and it and send to me  ?

I think most of my answers lie in comparing that file to mine.

[Patrick Sparkman]

I don't, no.  We don't have any C90s, but others might.