12-23-2009 12:15 PM - edited 03-17-2019 09:54 PM
I am configuring CTS Manager & Multipoint to interface with CA Spectrum management software through SNMP v2, the administrator of the CA Spectrun Software is asking for the MIBs & OID. From where I can get the MIBs & OIDs and which MIBs & OIDs I should send to CA Spectrum Management software administrator to work it properly with CTS Manager & Multipoint. CTS Manager & Multipoint are running software ver 1.6.
12-23-2009 01:19 PM
MIB information for the CTM and CTMS products can be found at the following locations:
CTS Manager:
http://www.cisco.com/en/US/partner/docs/telepresence/cts_manager/1_6/admin/ctm1_6adminguide.html
Chapter: Supported MIBs for Cisco TelePresence Manager
CTMS:
Chapter: Configuring CTMS Administration Software.
Half Way down the document below table 4-6 on SNMP Settings, It lists the FTP server where MIB support is listed.
Let us know if this does not provide what you need.
Thanks,
Wayne D.
12-24-2009 06:08 AM
And what are MIBs & OIDs required for CTS 3000 System.
12-24-2009 03:55 PM
ftp://ftp-sj.cisco.com/pub/mibs/supportlists/cts/cts-supportlist.html
For OID you can use any snmp translator once you install the MIB
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: