cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
305
Views
0
Helpful
3
Replies

Dial Pattern for Cisco SX20 to Polycom RMX

bharath01
Beginner
Beginner

Dear Team,

Pls help with the Dial Pattern that we had to use with Cisco SX20 for dialing out to Polycom RMX...

We are trying to create the same dial pattern for both Cisco SX20 & Polycom Group Series System; But we are not able to achieve it;

Polycom Format : Bridge ID - Dial Touch Tone - # Password #

Cisco Format : Bridge ID - Dial Touch Tone - Password #

Pls do the Needful help for same..

Regards,

Bharath

3 Replies 3

Joe Vallender
Participant
Participant

Do you have a registration device/server handling the call signaling for the endpoints?

Patrick Sparkman
VIP Alumni
VIP Alumni

What are you connecting to, where you're having to enter # password #, vs just password #?

Wayne DeNardi
VIP Alumni
VIP Alumni

I don't have access to a Polycom RMX to test, but there is lots of documentation available that says the formats to use to enter a password to a conference.

ie, if you have conference number "10001", with a conference password of "2222", on RMX with name "yourpolycom.com", you should be able to dial 10001$$2222@yourpolycom.com.

This should work from the Polycom or the Cisco endpoints.

Wayne
--
Please remember to mark helpful responses and to set your question as answered if appropriate.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: