dtmf-relay sip-notify

[John Cheetley]

Evening Cisco techs,

Having trouble enabling sip-notify

Using CME 3.3 via (C2691-IPVOICEK9-M), Version 12.4(25d), RELEASE SOFTWARE (fc1)

Have registered cisco phones set up in CME

SIP is enabled on router. So is H323

In conf t mode via voice service voip

Upon using dtmf-relay sip-notify I get the error of unrecognised command

If other information is required. Please let me know

[Terry Cheema]

Configure it under your dial-peers.

[John Cheetley]

Hi Terry,

Thanks for your quick response and time

Perhaps I missed something.

Can you please advise of a link for this thanks if that's not too much trouble?

[Terry Cheema]

Just go to your SIP dial-peers:

R01#conf t

R01#dial-peer voice XX voip    << XX is you SIP dial-peer

R01(config-dial-peer)#dtmf-relay ?
  cisco-rtp          Cisco Proprietary RTP
  h245-alphanumeric  DTMF Relay via H245 Alphanumeric IE
  h245-signal        DTMF Relay via H245 Signal IE
  rtp-nte            RTP Named Telephone Event RFC 2833
  sip-kpml           DTMF Relay via KPML over SIP SUBCRIBE/NOTIFY
  sip-notify         DTMF Relay via SIP NOTIFY messages

dial-peer voice 555 voip
 destination-pattern 55555
 session protocol sipv2
 session target ipv4:1.1.1.1
 dtmf-relay sip-notify

-Terry

[John Cheetley]

Evening Terry,

Unfortunately  I only have these options

cme_router(config-dial-peer)#dtmf-relay ?
  cisco-rtp          Cisco Proprietary RTP
  h245-alphanumeric  DTMF Relay via H245 Alphanumeric IE
  h245-signal        DTMF Relay via H245 Signal IE
  rtp-nte            RTP Named Telephone Event RFC 2833

I have both H323 and SIP enabled as below shows

voice service voip
 allow-connections h323 to h323
 sip to sip

[Terry Cheema]

This option will be visible under SIP dial-peer, your SIP dial-peer should have following command under the dial-peer:

 session protocol sipv2

[John Cheetley]

Thanks Terry for your reply.

That option is under the dial-peer I'm using

sip-ua confirms the service working.

However. When I run sh sip-ua register status.

Comes back advising no lines registered

[Wilson Samuel]

Just wondering are you using SIP Phones or SCCP Phones?

Could you please post your router CME config as well, please.

It will be much easier to tell once we have a look on the config.

HTH

[John Cheetley]

Hi Wilson,

Thanks for your reply. My apologies for my delay

Using SCCP phones thanks

Router CME config attached.

[John Cheetley]

Hi Wilson, 

Not to pester you. Just wandering if you have any information re the data I sent  you please?