Expressway Traversal Zone

[sakthivel.chandra1]

Hi,

we are setting a lab environment on expressway C and E and it is a single nic NAT scenario. We have configured Traversal zone client and server it was fine and in active state. but while configuring a unified communication traversal zone it is getting failed. Any help.

Regards

Sakthivel C

[Jonathan Robb]

Hi,

Would need a bit more information.  What is the error displayed on the Client side under status for the zone?

What errors are shown in the event log of the Expressway E and the Expressway C?

-Jonathan

[sakthivel.chandra1]

Hi Jonathan,

Thanks for your reply i have attached the event logs of both E, C,and also the screenshot of client status.I have attached the screenshot of Unified communication status of IMP.