ā11-19-2012 12:27 AM - edited ā03-18-2019 12:09 AM
Dear all,
We have configured the Template_jabber_4.4
Far End Camera Control | on |
In the client pc, we have installed the Cisco Jabber video for telepresence Versin 4.4.
However, during the conference, there is " far end camera control is not avaliable" in the video screen.
May I know any configuration that I have missed?
Best Regards.
Ben
ā11-19-2012 01:00 AM
Have you uploaded the 4.4 schema and created and assigned a 4.4 provisioning template with FEC set to "On" ?
/jens
ā11-19-2012 07:45 PM
As Jen mention above, unless you manually enable FECC in provisioning template and assign it to Jabber Video user, FECC wonāt enable on client.
ā12-17-2012 12:34 AM
We have confirmed that the Far End Camera Control turned ON in the Jabber 4.4 template.
However, the camera control did not show up.
Best Regards.
Ben
ā12-17-2012 02:37 AM
Does this happen with all sites, or just the one? Is the camera at the other site a camera that actually can be controlled by far end - and if so, are the other site allowing FEC?
As a side issue, upgrading to 4.5 is highly recommended.
/jens
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide