Is it possible to have two codec's connected to one camera

[leahdozier]

We are receiving lots of zoom invites and not all of our invites come from people with zoom's room connector.  As a result, I would like to register one codec to zoom and the other codec to Webex while using a single speaker track or quad camera.  I am thinking I could have a Touch10 for the Zoom codec and a separate Touch10/Navigator for the Webex codec.  Would this configuration be possible?

[Roger Kallberg]

I doubt that it would be supported or work. Why don't you use one codec and enable it to connect to Webex and Zoom? AFAIK you can configure a device to both do CRC with Zoom, but not set it to be provisioned by Zoom and then keep it as is for Webex, cloud or on-prem reg.

[Wayne DeNardi]

Depending on the model of the codec you are using, I think you'd probably be better off using the codec as usual with Webex, then using it to provide the audio and video over USB to a PC running Zoom as the second option.  There is a whole Webex Space on configuring the endpoints so they can be used this way PROJECT: USB Mode where all the designs and macros are available.