Multiple video feed to far end

[steven.gauthier]

Hello,

With a Cisco codec Pro or Codec Plus, when using the matrix commands,  I know it is possible to combine 2 video feeds, for example 2 camera side-by-side, and send that video to a local output. But would it be possible to send that video to the far end?

Thank you

[Wayne DeNardi]

With the command

xCommand Video Layout LayoutFamily Set

there is a "Target" option for Local or Remote.  This allows you to select if the target for the layout you are applying is the "local" layout (what users of the current device will see) or the "remote" layout (what participants at the far end will see).

[steven.gauthier]

Unless I am missing something, I am not sure this will work. What I am doing is sending my 2 camera feeds to one of my outputs with these 2 commands

xcommand video matrix assign layout:equal mode:replace output:2 sourceid:1

xcommand video matrix assign layout:equal mode:add output:2 sourceid:2

Afterwards, I would like to send the same image to the far end,  I am not sure how I would achieve that with the layout command