This is the first time I'm configuring MX300G2 and SX80 for a client using CUCM 11.5.x, I followed the below link to configure the SX80 and MX300.
and my endpoints are successfully registered and functioning properly.
during the tests I found that when I restart the device it wont register back with CUCM.
On webpage of SX80 I have found that on SIP page that default transport changes back to TLS after restart.
On webpage of MX300G2 I have found that on SIP page that URI field appears blank and in order to register it back i have to put it manually after restart.
Please help me to fix this issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: