we had migrated some new (old) Videoendpoints.
Actually we have trouble with an 6000MXP (F9.0.2 PAL). The problem is we have an multisidfe option installed and so the Endpoint
is not using the MCU. How can we convince these endpoint to use the MCU?
Tnaks a lot!
Solved! Go to Solution.
Through web GUI: Endpoint Configuration-->General-->Multi Point Call Options-->Multi Point
choices are Off, Multisite or Multiway - select Multisite.
xConfiguration Multipoint Mode:
xConfiguration Multipoint Mode: Multisite
Also remember to set "Allow Incoming Calls when in Call" permission to "On" if you want to allow other sites to dial in for mutisite conferences.