I am trying to run auto qos on a 6509-E but the option isn't there. I have tried enabling mls qos from global config, but the auto qos under interface config mode still doesn't show up. Any ideas? We need to use auto qos as a temporary measure. Thanks.
IOS version 12.2(18)SXF8
MDF#show mod
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 8 8 port 1000mb GBIC Enhanced QoS WS-X6408A-GBIC
2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX
3 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX
4 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX
5 9 Supervisor Engine 32 8GE (Active) WS-SUP32-GE-3B
6 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX
8 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX
9 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-45AF
MDF#sh run int g9/20
Building configuration...
Current configuration : 192 bytes
!
interface GigabitEthernet9/20
switchport
switchport access vlan 6
switchport mode access
switchport voice vlan 995
no ip address
spanning-tree portfast
end
MDF#conf t
Enter configuration commands, one per line. End with CNTL/Z.
MDF(config)#int g9/20
MDF(config-if)#auto ?
% Unrecognized command
MDF(config-if)#auto?
% Unrecognized command
MDF(config-if)#au?
% Unrecognized command