No Endpoint's name when conference with SX20 Multisite

[Ferdi0802]

Hi,

I setup a lab which consist 2 SX20 and 1 EX60. Using SIP and no call control, I try to conference with SX20 multisite capability (just call using prefix@IP). But, I notice there is no name display below each participant in the video. Is that normal behavior? I have configured display name on each endpoint.

[Wayne DeNardi · Accepted solution]

Yes, that is normal behaviour.  The names of the participants will appear when using a MCU, and only if it is configured to do so.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.