01-03-2007 12:24 AM - edited 03-17-2019 08:54 PM
has anyone been able to register a polycom sip phone on a callmanager express? i especially need help on configuring the polycom phone
01-03-2007 04:06 AM
I have not been able to get the 3rd Party Polycom SIP phone to register with Call Manager Express either. The feedback I am getting is that 3rd Party SIP Phones are curently not being supported on Call Manager Express.
01-03-2007 07:41 AM
Hi Shawn/Dennis,
Have a look at this good note from Tony Huyhn, a technical marketing engineer for Cisco CallManager Express (CME) at Cisco Systems. This answer is from a current "Ask the Expert" event on CME.
Yes, you can register (Cisco only) sip phones to CME as of CME 3.4, IOS 12.4(4)T
Here is the thread;
Hope this helps!
Rob
01-03-2007 11:44 PM
thanks for the link, Rob.
I actually was able to get one of the Line buttons to register on CME as an extension. i can make calls to other extensions and call this extension but am unable to call out the PSTN.
the phone doesn't register though, but the line button does. not very familiar with Polycom phones which is my issue.
06-27-2007 08:06 AM
I just got this to work with a SoundPoint 501. Took some fiddling, but phone is registered and seems to work Ok. Still working on some issues with WMI and getting the messages button to work correctly, but the phone is registered.
here is the config:
voice register global
mode cme
source-address 10.72.13.19 port 5060
max-dn 200
max-pool 20
timezone 13
tftp-path slot0:
create profile sync 0390651099874124
ntp-server 10.71.13.19 mode directedbroadcast
!
voice register dn 1
number 4020
allow watch
!
voice register template 1
session-transport udp
softkeys hold Resume Newcall
softkeys idle Newcall Redial Cfwdall
softkeys connected Endcall Trnsfer Confrn Hold
voicemail 4200 timeout 30
!
voice register dialplan 1
type 7940-7960-others
pattern 1 4...
pattern 2 ....
pattern 3 .
!
voice register pool 1
id mac 0004.F213.2465
type P600
number 1 dn 1
dialplan 1
dtmf-relay rtp-nte
voice-class codec 1
02-24-2010 07:39 AM
Hi derek
I saw you reply , do i need to do anything other than above configuration
do i need any files on the TFTP server for polycom, i am trying to configure polycom 560
Thanks
Sri
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide