11-28-2017 06:46 AM - edited 03-18-2019 01:39 PM
I hace camera IPC-6400. I must use the protocol rtsp for connected on the nvr third party. Is there somebody that know the URL RTSP? Thanks
12-05-2017 09:41 PM - edited 12-05-2017 09:42 PM
Being an ONVIF camera, you may be able to find out the RTSP stream URL by using ONVIF Device Manager. I've used this a couple of times for other Manufacturer's cameras, but haven't specifically tried it on the Cisco 6400.
Please remember to mark helpful responses and to set your question as answered if appropriate.
12-06-2017 03:57 AM
I use the software "Onvif Device Test Tool", but when i test the camera the response is " Sender not authorized". The user and password is correct. " <SOAP-ENV:Body>
<SOAP-ENV:Fault>
<SOAP-ENV:Code>
<SOAP-ENV:Value>env:Sender</SOAP-ENV:Value>
<SOAP-ENV:Subcode>
<SOAP-ENV:Value>ter:NotAuthorized</SOAP-ENV:Value>
</SOAP-ENV:Subcode>
</SOAP-ENV:Code>
<SOAP-ENV:Reason>
<SOAP-ENV:Text xml:lang="en">Sender not authorized</SOAP-ENV:Text>
</SOAP-ENV:Reason>
</SOAP-ENV:Fault>
</SOAP-ENV:Body>
</SOAP-ENV:Envelope>"
I enabled "Onvif" and "disable session id"
12-10-2017 03:08 PM
Did you enter the right username and password in to the tool?
Please remember to mark helpful responses and to set your question as answered if appropriate.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: