cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1011
Views
0
Helpful
4
Replies

SIP call doesn't disconnect

Pasha Teplitsky
Level 1
Level 1

Hi guys,

i'm doing some pre sale testing for a customer. he wants to use cisco router as a sip proxy. either in CME mode or as a ip2ip gw.

i tried 2 configurations with the clients SIP softphone.

1. CME config while i register the sip softphones.

2. ip2ip gw while i use dial peer voip with session protocol sipv2 to point to the ip add for the extension.

tests were doing great up untill the calee tried to hang up.

when the callee hangs up, a bye msg is sent to the router and the callee leg disconnects but the bye msg never gets to the caller!

and this leg stays up.  i run several debugs including debug ccsip all and saw no errors. it seems like the router is fine with everything.

i never have a problem while the caller hangs up. the session ends just fine on both call legs.

this happens both in CME and ip2ip configurations.

i've tried the same with another softphone and everything was working great!

the only difference i saw was this:

on the other softphone i used, the BYE message that was generated by the callee had a CSEQ value greater than the INVITE (generated by the caller).

on the clients softphone the CSEQ of the BYE message (from the callee) was initial. ie- 1.

i've done some research on the issue and everything works out just fine by IETF rules.

since the INVITE came from the caller with CSEQ 1, if the caller would send the BYE it should have had CSEQ 2, but since

its the callee that sends the BYE and this is the first initiation from its behalf, CSEQ indeed should be 1.

any thoughts about this?

4 Replies 4

What is the IOS version used on your router?

Post also the config.

Regards.

I use IOS

c2801-advipservicesk9-mz.124-24.T5.bin

with the following config (please note that cme and dial-peers are not configured at the same time...)

R_Main-Site-A#sh run

Building configuration...

Current configuration : 10702 bytes

!

! Last configuration change at 14:52:13 UTC Wed Oct 5 2011

!

version 12.4

service timestamps debug datetime msec

service timestamps log datetime msec

no service password-encryption

service sequence-numbers

!

hostname R_Main-Site-A

!

boot-start-marker

boot-end-marker

!

logging message-counter syslog

!

aaa new-model

!

!

aaa authentication login default local

!        

!

aaa session-id common

network-clock-participate wic 2

network-clock-select 1 E1 0/2/0

dot11 syslog

ip source-route

!

ip cef

no ip domain lookup

ip domain name vc.lab

ip multicast-routing

no ipv6 cef

!

multilink bundle-name authenticated

!

!        

!

!

isdn switch-type primary-net5

!

!

!

voice service voip

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

redirect ip2ip

fax protocol cisco

h323

  h225 timeout setup 3

sip

  bind control source- interface FastEthernet0/1.501

  bind media source- interface FastEthernet0/1.501

  header-passing

  registrar server

!

!

!

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

!

!

!

!

voice class h323 1

  h225 timeout tcp establish 3

!

!

!

!

!

!

!

!

!

voice register global

mode cme

source-address 172.16.10.253 port 5060

max-dn 144

max-pool 24

!

voice register dn  1

number 710

!

voice register dn  2

number 720

!

voice register dn  3

number 730

!

voice register pool  1

busy-trigger-per-button 50

id mac 5CFF.350C.16E3

number 1 dn 1

!

voice register pool  2

busy-trigger-per-button 50

id mac 0014.5E6B.1564

number 1 dn 2

voice-class codec 1

!

voice register pool  3

busy-trigger-per-button 50

id mac 0021.5ACB.40C2

number 1 dn 3

voice-class codec 1

!

!

!

controller E1 0/2/0

pri-group timeslots 1-4,16 service mgcp

!

!

!

interface FastEthernet0/0

no ip address

duplex auto

speed auto

!

interface FastEthernet0/1

no ip address

duplex auto

speed auto

!

interface FastEthernet0/1.11

encapsulation dot1Q 11

ip address 172.16.11.253 255.255.255.0

!

interface FastEthernet0/1.501

encapsulation dot1Q 501

ip address 172.16.10.253 255.255.255.0

!

interface Serial0/1/0

no ip address

encapsulation frame-relay

no fair-queue

clock rate 2000000

frame-relay lmi-type cisco

!

interface Serial0/1/0.16 point-to-point

description ****** Connected To Site-C Serial 0/1/0 ******

ip address 10.10.10.1 255.255.255.252

ip pim dense-mode

snmp trap link-status

frame-relay interface-dlci 16  

!

interface Serial0/1/1

no ip address

encapsulation frame-relay

no fair-queue

!

interface Serial0/1/1.17 point-to-point

description ****** Connected To Site-B Serial 0/1/0 ******

ip address 10.10.10.6 255.255.255.252

ip pim dense-mode

snmp trap link-status

frame-relay interface-dlci 17  

!        

interface Serial0/2/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

!

ip local pool SSLVPNphone_pool 172.16.10.80 172.16.10.90

ip forward-protocol nd

ip route 0.0.0.0 0.0.0.0 172.16.10.254

ip route 172.16.10.0 255.255.255.0 FastEthernet0/1

ip route 172.16.30.0 255.255.255.0 10.10.10.2

ip http server

ip http authentication local

ip http secure-server

!

!

!

ip sla responder

disable-eadi

!

!        

!

!

!

snmp-server community read RO

snmp-server community write RW

snmp-server community public RO

!

control-plane

!

!

!

dial-peer voice 999 voip

destination-pattern 700

session protocol sipv2

session target ipv4:172.16.10.2

dtmf-relay sip-notify

codec g711ulaw

no vad

!

dial-peer voice 998 voip

destination-pattern 705

session protocol sipv2

session target ipv4:172.16.10.1

dtmf-relay sip-notify

codec g711ulaw

no vad

!

dial-peer voice 996 voip

destination-pattern 702

session protocol sipv2

session target ipv4:172.16.10.3

dtmf-relay sip-notify

codec g711ulaw

!

dial-peer voice 995 voip

destination-pattern 703

session protocol sipv2

session target ipv4:172.16.10.210

dtmf-relay sip-notify

codec g711ulaw

!

dial-peer voice 994 voip

destination-pattern 704

session protocol sipv2

session target ipv4:172.16.10.200

dtmf-relay sip-notify

codec g711ulaw

!

dial-peer voice 993 voip

destination-pattern 706

session protocol sipv2

session target ipv4:172.16.10.201

dtmf-relay sip-notify

codec g711ulaw

!

dial-peer voice 992 voip

destination-pattern 701

session protocol sipv2

session target ipv4:172.16.10.100

dtmf-relay sip-notify

codec g711ulaw

!

!

sip-ua

registrar ipv4:172.16.10.253 expires 3600

!

!

line con 0

line aux 0

line vty 0 4

privilege level 15

line vty 5 15

privilege level 15

!

scheduler allocate 20000 1000

ntp master

ntp server 172.16.10.253

!

!

end

Can you add the debug ccsip messages output?

Regards.

Simerpreet Singh
Cisco Employee
Cisco Employee

please post the sip debugs or sniffer capture for the call.

debugs

simple

debug ccsip messages

advanced

deb ccsip all     <>

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: