08-15-2017 05:34 AM - edited 03-18-2019 01:24 PM
Hi
there is any option to connect 2 cisco touch screen 10" to the room kit?
the table in the room is big and the client think to our 2 touch screens on the table
thansk
shy
08-15-2017 08:53 PM
Similar question came up regarding the SX80, see sx80-and-dual-touch-10, and since the Spark Room Kits run CE software it should be possible. However using more than one Touch 10 with a codec isn't officially supported by Cisco.
02-28-2018 11:55 AM
Yes, you can. However, you have to factory default the unit (if already registered via Spark). Then add as many Touch10s needed and point them all to the IP of the CODEC. PITA that you have to reset, but it can and has been done on my SX10.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: