Standalone SX10 ip dialing to polycom MCU RMX500

[fei ge]

Hi,Experts

Have you ever test the situation that standalone SX10 ip dialing to polycom MCU RMX500？is it possible（no vcs or cucm）

[vikdutta]

Hi,

Why not ?  It is possible.

Check where RMX 500 is placed. ie in Lan, DMZ or public internet.

If RMX is on lan>  just dial the dialable pattern from SX 10 which RMX understands ie conf code, uri, ip etc to join a meeting.

If RMX is on public, configure nat ip on SX 10. allow SX 10 subnet on Firewall, throw a call to RMX.

Note***  you will face some media issues initially. firewall should be flexible enough to be configured 

to allow rtp dual stream h239/bfcp. etc etc.

//VD  

[Wayne DeNardi]

If the Polycom has been configured to support SIP in-dial then there should be no issues.

If the Polycom is H.323 only, you will need a VCS (or similar) to do the interworking between SIP and H.323.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.