Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
565
Views
3
Helpful
1
Replies

Standby activation with Touch Controllers

stanley.april
Level 1
Level 1

‎07-06-2011 05:58 AM - edited ‎03-17-2019 10:22 PM

How do you manually activate the standby mode on C series video units using the Touch Screen Panel? I know on the remote control you just hold the red end call button for five seconds. I cannot find any documentation .

Labels:
0 Helpful
1 Reply 1

Teck Chye Tang
Cisco Employee
Cisco Employee

‎07-13-2011 06:51 AM

Hi,

You are not able to do this now with any of the current software release.

In the upcoming TC4.2 release, for the c-series codecs,  there will be a button on the top left corner of the touch screen that allows you to do that.

However, in EX90/Ex60, you will not see this button.  For EX90/EX60, now you can already put the unit to standby by pressing the power button switch on the unit.

Customers Also Viewed These Support Documents