Dear Cisco community,
I recently got hold of an outdated TTC60 teleconference system. We are currently not planning to use the "PC" part (in the lower compartment of the system), rather I already installed a Raspberry PI which is connected to HDMI 1 and a wireless HDMI extender on HDMI 2.Problem is that I haven't found a way to switch between the 2 HDMI inputs. I reconnected the conference system and checked all settings in the menu to see if I can use the 5 top-most buttons on the TRC 4 remote control to configure HDMI 1 on button 1 and HDMI 2 on button 2, but also can't find any configuration options to switch between HDMI inputs anywhere.
I hope someone can guide me to a way of how I can utilize both HDMI inputs.
Thank you in advance for your support!
Best regards,
Sascha
