cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3117
Views
0
Helpful
2
Replies

TCP/UDP port usage for the EX90

rfrome
Level 1
Level 1

Does anyone have a list of port usage for the EX90s they can share?

2 Replies 2

t.svatek
Level 3
Level 3

there is no Port reference for any Endpoint like EX90, EX60 and C-Codecs. The Port References for TMS, MCU and VCS are also very different.

You can advise the needed ports by looking into this doc:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_IP_Port_Usage_for_Firewall_Traversal_Deployment_Guide_X4_to_X7.pdf

I wish for christmas a complete port reference for all boxes.

Hello,

There were these documents H323 and SIP but these are now outdated I believe as you can set the range of media ports use in the codecs by the commands ...

xConfiguration RTP Ports Range Start: 2326

xConfiguration RTP Ports Range Stop: 2486

in the later releases of TC software (TC4/5), so now for the media you can define the port range used.  SIP and H323 signalling will still use the ports mentioned in the documentation.

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: