05-20-2014 04:44 AM - edited 03-18-2019 03:00 AM
hello all,
for last 2 years we are in trouble with an unresolved problem on calls that routed cucm --> vcs --> tpserver.
some calls are looked like connected on vsc but the condition is "joining" in the mse 8710 and after timeout the call has been disconnected.
I am looking forward for you advices.
on the case 2 years ago, cisco said that new verison (v3) will solve but not solved.
05-20-2014 11:30 PM
Can you please let us know a bit more about your deployment, what protocols are used, what versions of software are running on each of the components, etc. It's harder to guess what's going on when there's not a lot of information on your environment.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
05-20-2014 11:39 PM
sure,
cucm 8.6.2
vcs 7.2.2
tpserver 2.3.1.55
protocol between cucm and vcs is SIP
tpserver and its numbers are registered to vcs within default zone.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: