Use the 2.nd ethernet port on C.60 Codec for controling.

[Henning Koch Telving]

Hi.

Is it possible to use the 2.nd ethernet port on a c60 codec for sending x.commands to the codec.

My problem is that the controlsystem (AMX) is on a separate, internal network.

Regards.

Henning Telving

[mubakhta]

Hi Henning,

The second ethernet port is only used for connecting the Touch Panel to the codec directly so that it can be paired. It cannot be used to send xcommands.

I dont think you can use the AMX control on a different network. I would recommend that you visit the link below for better assistance for AMX :

http://developer.cisco.com/web/tandberg-developer/

Regards,

Mubashshir Akhtar