cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1655
Views
0
Helpful
3
Replies

VCS equivalent of Calling Party Transformation Mask in the CUCM

I am trying to change the calling party ID using a VCS.  This can be done easily with a CUCM by creating a Route Pattern and using the "Calling Party Transformation Mask".  Does anyone know how to do this same thing via a VCS?

2 Accepted Solutions

Accepted Solutions

gubadman
Level 3
Level 3

Hi Rachel,

This post might help - https://supportforums.cisco.com/thread/2128626 as it has some suggestions.

Thanks,

Guy

View solution in original post

awinter2
Level 7
Level 7

Hi Rachel,

with the current VCS software (X7) you have two options, FindMe Source Rewrite and CPL-based static source rewrite.

FindMe Source rewrite is described in more detail in the VCS Administrator's guide.

For CPL-based static source rewrite, please check out the following forum post for more information:

https://supportforums.cisco.com/message/3711482#3711482

In the upcoming X8 software for the VCS, it will become possible to perform dynamic regex-based source rewrite through CPL, which adds a lot more flexibility.

View solution in original post

3 Replies 3

gubadman
Level 3
Level 3

Hi Rachel,

This post might help - https://supportforums.cisco.com/thread/2128626 as it has some suggestions.

Thanks,

Guy

Thank you both for your quick responses!  This was very helpful.

awinter2
Level 7
Level 7

Hi Rachel,

with the current VCS software (X7) you have two options, FindMe Source Rewrite and CPL-based static source rewrite.

FindMe Source rewrite is described in more detail in the VCS Administrator's guide.

For CPL-based static source rewrite, please check out the following forum post for more information:

https://supportforums.cisco.com/message/3711482#3711482

In the upcoming X8 software for the VCS, it will become possible to perform dynamic regex-based source rewrite through CPL, which adds a lot more flexibility.