cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
configure & troubleshoot anyconnect
159
Views
5
Helpful
3
Replies
Highlighted
Beginner

A three-inch wide section of the DX80 screen has become unresponsive

Hello community,

 

One of our DX80s has become unresponsive in a three-inch wide section of the screen following a factory reset. This means that we cannot set it up as crucial parts of the screen are in the the unresponsive area. 

 

We've raised a case with Cisco who have not been able to diagnose the problem and we're just out of the warranty period.

 

Has anyone experienced similar and did you find a solution?

If not, can it be sent for repair?

 

Thanks,

 

Kieran

 

Attn: @FreyaCrawshaw 

3 REPLIES 3
VIP Advisor

Re: A three-inch wide section of the DX80 screen has become unresponsive

If you put the device under a Cisco Service Contract, then you will be able to RMA it via the Cisco TAC.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Beginner

Re: A three-inch wide section of the DX80 screen has become unresponsive

Thanks Wayne. How can I put our devices under a service contract?

VIP Advisor

Re: A three-inch wide section of the DX80 screen has become unresponsive

Your local Cisco Partner should be able to sell you Service Contracts for your endpoint(s).

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
CreatePlease to create content