You can make calls from one Cisco ATA to another Cisco ATA in an H.323 network that does not contain an H.323 gatekeeper.
For one Cisco ATA to access a specific FXS port on another Cisco ATA, you use an IP dialing procedure. The Cisco ATA originating the call must have the following information about the destination Cisco ATA:
â¢E.164 phone number of the destination FXS port
â¢IP address of the destination Cisco ATA
To enable the IP dialing procedure, you need to set the IPDialPlan parameter to 1 to instruct the Cisco ATA to look for the destination IP address in the dialed digits.
Cisco ATA X is going to initiate a call to Cisco ATA Y (with the following pertinent information):
â¢IP address of Cisco ATA Y-192.168.2.112.
â¢E.164 phone number for the Phone 1 port of Cisco ATA Y-1:5556666
â¢E.164 phone number for the Phone 2 port of Cisco ATA Y-2:5558888
To call the Phone 1 port on Cisco ATA Y, you would dial 5556666**192*168*2*112#.
To call the Phone 2 port on Cisco ATA Y, you would dial 5558888**192*168*2*112#.
Today, Cisco announced new advances for meetings. A couple of insights:
1. Scheduling meetings is even easier
2. New video devices
3. New headsets
Click here to learn more about these exciting advances in Cisco meeting technolog...
How does the phone registered in CUCM environment?
-The phone will obtains power via PoE or AC adapter.-The phone will loads its locally stored firmware image.-The phone learns the voice vlan id via cdp from the switch.-Via...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about the concepts, best deployment practices and troubleshooting tips for Webex Hybrid services. Ask qu...